Reference Citations - HerongYang.com - v2.91, by Dr. Herong Yang
Getting Up and Running with OpenMoco Slim
'Installing NMake 1.5' tutorial was cited in a user comment on OpenMoco installation guide in 2010.
The Installing NMake 1.5 tutorial was cited in a user comment on OpenMoco installation guide in 2010.
Subject: Getting Up and Running with OpenMoco Slim Date: 03/27/2010 Author: CaptiveLight Source: http://www.openmoco.org/node/98 Sorry if this is a dumb question, but I don't have much experience with command prompts. I'm following the above instructions. I've installed nmake per these instructions: http://www.herongyang.com/Perl/RPC-XML-Install-NMake.html Now I'm at the part where I change directories (which I did) then I type perl Makefile.#007788;">PL and I get Can't open perl script "Makefile.#007788;>PL": Invalid arguement Any ideas on what I'm doing wrong? ...
Table of Contents